Nutone Fan Upgrade Kit CT7090 for 0695B000 0696B000 QT80 QT110 New Easy Install

  

Get a New Quiet Energy Efficient Fan Upgrade. For your old Nutone QT80 or QT110. Complete Upgrade Assembly, It replaces your old motor, blower wheel, motor plate and blower housing. Quieter by over 50% Our unit is rated at 0.4 sones at 70 cfm & 1.2 at 90 cfm. Our unit uses over 50% less energy than the original assembly.

Moves as much air as your old unit. Great value, compared to having to install a whole new fan with installation labor, etc. Everything needed to replace your old worn out noisy fan unit is included, except the grille and installed housing. Installs easily with a Phillips head screwdriver in less than 5 minutes.

Built in speed switch which allows you to set the fan for either 70 cfm or 90 cfm. It replaces part numbers 0696b000 or 0695b000,1307A000,5901A000.

This is not manufactured by Nutone. Note: Will not work in the versions of the above fans with lights.

Disconnect the electrical power supply and lock out the service panel for the existing fan. Remove the grille from existing fan. Pull grille down to expose two springs. Squeeze each spring together and pull down again to release springs from motor plate slots.

Remove existing blower motor assembly. Loosen three existing Phillips head screws.

Slide blower assembly forward to center of slots. When blower assembly is released from screws pull down on assembly slightly to expose motor cord. Unplug motor cord from receptacle. Set existing blower motor assembly aside.

Remove three (3) existing mounting screws from housing and discard. Remove three (3) new screws and white spacers supplied with you new fan upgrade kit.

Install one spacer on each new screw. Install new screws into housing, in the same location of old remove screws. Leave at least ½ inch gap. Vacuum the interior of existing fan housing with a dusting brush or something similar.

Examine the housing to make sure it is secure and free of any hole caused by corrosion. The receptacle must be intact. If any damage is found, do not continue with installation of this product. Contact a qualified person(s) for repair.

Install new upgrade assembly into existing housing. Position assembly into housing area to plug motor cord into the housing receptacle. Position assembly to align three new screws to slots in new motor plate. Insert new motor plate into housing. (Plate should be positioned to be at the end of the slots) Hold motor plate and tighten three (3) new screws. Squeeze one grille spring together and insert into the matching slot in new motor plate. Repeat with the second grille spring. Push grille into place against ceiling.

Reconnect (turn power back on) electrical supply to the fan circuit. To select which speed to operate your new fan. Switch on motor plate has two positions. One (1) dot equals 70cfm Two (2)dots equals 90cfm. The item "Nutone Fan Upgrade Kit CT7090 for 0695B000 0696B000 QT80 QT110 New Easy Install" is in sale since Friday, December 1, 2017.

This item is in the category "Home & Garden\Home Improvement\Heating, Cooling & Air\Air Conditioners & Heaters\HVAC Parts & Accessories". The seller is "rockyginger" and is located in San Jose, California. This item can be shipped to United States.

• Country of Manufacture: United States
• Country/Region of Manufacture: China
• Type: Bathroom Fan
• MPN: CT7090
• Brand: Nutone
• Model: CT7090